A lot more than 50% of the compression and pumping systems above 3 MW require a variable-speed drive. Often medium-voltage motors fed by frequency converters and parallel shaft gears are selected. Others are employing epicyclic gears with a hydrodynamic superimposition drive.

Taking benefit of the state of the art in electric powered motors and frequency converters, the driving program for the superimposition of the earth carrier is based on a Long lasting Magnet Synchronous Superimposition (SI) engine and an Active Front-End Cycle Converter. So – E means Electric.
This is a high-speed gear drive system incorporating elements that allow the Variator Gearbox utilization of a low-cost constant-speed (electric) driver for a variable-speed application.

A lot more than 50% of the compression and pumping systems above 3 MW need a variable-speed drive. Frequently medium-voltage motors fed by frequency converters and parallel shaft gears are chosen. Others are using epicyclic gears with a hydrodynamic superimposition drive.
It started with hydraulic fluid couplings creating slippage with results very little better than the throttle.
The look of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Variable Frequency Drives (VFD) were developed and, simultaneously, the expense of the shaft trains increased, and so did efficiency. The problem of THD (Total Harmonic grid Distortion) rose and held VFD out of several applications.

Taking advantage of the state of the artwork in electric motors and frequency converters, the driving system for the superimposition of the planet carrier is based on a Long term Magnet Synchronous Superimposition (SI) engine and an Active Front-End Cycle Converter. Therefore – E stands for Electric.
This is a high-speed gear drive system incorporating elements that allow the use of a low-cost constant-speed (electric) driver for a variable-speed application.

All of the above plots were taken by analyzing the existing to the motor. In a normal situation, the vibration will end up being monitored and kept on a periodic basis. If the 360 Hz signal exists in the vibration spectrum, it isn’t normally of any concern. If, however, other unexplained frequencies appear in the vibration spectra, after that it would be advisable to check out both the current waveform and the existing spectrum. In the web pages that follow, some examples of problems discovered in DC drives and motors are provided.”
It started with hydraulic liquid couplings producing slippage with results not much much better than the throttle.
The design of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Variable Frequency Drives (VFD) were developed and, simultaneously, the price of the shaft trains improved, and so did efficiency. The problem of THD (Total Harmonic grid Distortion) rose and kept VFD out of several applications.