Energy UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is developed exclusively for that tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become widely employed from the market of logistic devices for instance minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed by the solenoid valve with all the pace controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is built exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a large positoin, but the power supply is lower, the lowering movement is controlled by the guide override perform.
Electrical power UNITS FOR LIFT TABLE three
General Description
This energy unit is made solely for your massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve plus the speed managed by a stress compensated flow management valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This electrical power unit is designed exclusively for that large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is minimize, the decreasing movement is managed by the manual override function.
Particular Notes
1. This energy unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned in advance of installation of the energy unit.
3. Viscosity of the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
4. Oil transforming is required just after the initial a hundred operation hrs,afterwards once each 3000 hrs.
five. The power unit proven is designed to be mounted vertically.