Materials Handling Electrical power UNIT two
General Description
This energy unit capabilities power up gravity down circuit. Activate the start out solenoid to begin the motor to lift the machine. The lowing movement is activated from the solenoid valve using the decreasing pace managed through the strain compensated flow management valve. Solutions of this series is usually widely used in the sector of logistic devices for example fork lift, mini lift table, and so on.
Unique Notes
1. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned in advance of mounting the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which should also be clean and free of charge of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is required following the preliminary 100 operation hours,afterwards after just about every 3000 hours.
five. The electrical power unit need to be mounted horizontally.

Material Handling Power UNIT 1
Basic Description
This electrical power unit is intended for your fork lift industry, consisting of extremely effective gear pump, DC motor, manual raise and reduce valve, tank, ect. The up and down movement are controlled from the lever with the guide release valve, that is outfitted with an electrical switch to activate the motor. The lowing speed is managed by the strain compensated flow handle valve.
Special Notes
1. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean every one of the hydraulic elements concerned just before set up of the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which must also be clean and cost-free of impurities, N46 hydraulic oil is advisable .
four. Oil altering is required immediately after the first one hundred operation hours, afterwards the moment every 3000 hrs.
5. The power unit shown is made to be mounted horizontally.