As servo technology has evolved-with manufacturers producing smaller, yet better motors -gearheads are becoming increasingly essential companions in motion control. Locating the ideal pairing must consider many engineering considerations.
• A servo engine running at low rpm operates inefficiently. Eddy currents are loops of electrical current that are induced within the motor during operation. The eddy currents actually produce a drag push within the engine and will have a larger negative effect on motor performance at lower rpms.
• An off-the-shelf motor’s parameters may not be ideally suited to run at a minimal rpm. When a credit card applicatoin runs the aforementioned engine at 50 rpm, essentially it isn’t using all of its obtainable rpm. As the voltage constant (V/Krpm) of the engine is set for an increased rpm, the torque constant (Nm/amp)-which is usually directly linked to it-is lower than it needs to be. Because of this, the application needs more current to operate a vehicle it than if the application had a motor specifically made for 50 rpm. A gearhead’s ratio reduces the engine rpm, which explains why gearheads are occasionally called gear reducers. Utilizing a gearhead with a 40:1 ratio,
the electric motor rpm at the input of the gearhead will be 2,000 rpm and the rpm at the output of the gearhead will be 50 rpm. Operating the motor at the bigger rpm will allow you to avoid the concerns

Servo Gearboxes provide freedom for how much rotation is achieved from a servo. Most hobby servos are limited by just beyond 180 levels of rotation. Many of the Servo Gearboxes make use of a patented exterior potentiometer so that the rotation quantity is in addition to the equipment ratio set up on the Servo Gearbox. In this kind of case, the small equipment on the servo will rotate as many times as necessary to drive the potentiometer (and therefore the gearbox output shaft) into the position that the signal from the servo controller demands.
Machine designers are increasingly embracing gearheads to take benefit of the most recent advances in servo motor technology. Essentially, a gearhead converts high-rate, low-torque energy into low-speed, high-torque output. A servo electric motor provides extremely accurate positioning of its result shaft. When these two products are paired with each other, they promote each other’s strengths, offering controlled motion that’s precise, robust, and dependable.

Servo Gearboxes are robust! While there are high torque servos out there that doesn’t imply they can compare to the strain capability of a Servo Gearbox. The tiny splined output shaft of a regular servo isn’t long enough, large enough or supported well enough to handle some loads even though the torque numbers appear to be suitable for the application. A servo gearbox isolates the load to the gearbox output shaft which is supported by a pair of ABEC-5 precision ball bearings. The external shaft can withstand intense loads in the axial and radial directions without transferring those forces on to the servo. Subsequently, the servo operates more freely and is able to transfer more torque to the output shaft of the gearbox.